Calculate cubic yards, bags needed, and New Orleans LA-accurate ready-mix costs for any concrete project — elevated slabs, driveways, patios, pilings, foundations & more.
Enter your project dimensions to calculate volume, bags needed, and estimated New Orleans LA material cost.
Residential driveway: 5–6 in. min, 3,500 PSI. Type V sulfate-resistant cement recommended over NOLA clay. Orleans Parish permit required.
Driveway 5–6 in · Elevated slab 5–6 in · Piling cap 12–18 in · Foundation 8–10 in
New Orleans is arguably the most challenging city in North America for concrete construction. Sitting in the Mississippi River delta at an average elevation of −6 feet below sea level, the city is built on extraordinarily soft, waterlogged deltaic sediments that continue to subside at 1–2 inches per year in many neighborhoods. This means that standard on-grade slab construction is often not appropriate for structural purposes — foundations typically require concrete pilings driven to load-bearing soil, sometimes 40–80 feet below grade. Concrete flatwork must also contend with year-round high humidity, no frost cycle, sulfate-rich saturated soils, and aggressive hurricane-season construction demands. The Louisiana State Licensing Board for Contractors (LSLBC) licenses all contractors — verify at lslbc.louisiana.gov. The City of New Orleans permits are managed by the Department of Safety and Permits at (504) 658-7100.
Driveways & Flatwork: 3,500 PSI min, #4 rebar, Type V sulfate-resistant cement recommended over NOLA clay · Elevated slabs: 3,500–4,000 PSI, must be placed above Base Flood Elevation (BFE) per FEMA flood zone requirements · Piling foundations: 4,000–5,000 PSI, driven concrete or auger-cast pilings to load-bearing strata · W/C ratio: max 0.45 for all below-grade or ground-contact concrete due to sulfate exposure · No frost depth: New Orleans has essentially zero frost depth — but FEMA flood elevation requirements replace frost as the critical footing design constraint · Hurricane wind: All structural concrete in New Orleans must comply with ASCE 7 wind load requirements for a 130+ mph design wind speed. Contact City of New Orleans Safety and Permits at (504) 658-7100.
New Orleans' signature residential construction method is the elevated pier-and-beam or piling-supported slab, raising the living floor above Base Flood Elevation (BFE). Most New Orleans properties sit in FEMA flood zones where finished floors must be 1–3 feet above BFE. This drives unique concrete requirements — elevated slabs are typically 5–6 inch, 3,500–4,000 PSI concrete on formed decking supported by concrete pilings or CMU piers. The void space below must remain open and ventilated per FEMA flood insurance requirements. Never fill in the void below an elevated structure without a licensed engineer's approval and an Orleans Parish permit.
New Orleans sits on 100+ feet of soft Mississippi River deltaic deposits that consolidate under load, causing ongoing subsidence throughout the metro area. Rates of 1–2 inches per year are common in many neighborhoods, and some areas sink even faster. This means on-grade concrete slabs — driveways, patios, sidewalks — will often crack and settle over time regardless of concrete quality. For any structural concrete in New Orleans, always use a geotechnical engineer to design the foundation system and specify piling depth. Driveways and sidewalks should be poured with control joints every 6–8 feet to control cracking as the ground settles.
New Orleans' saturated soils and brackish groundwater are rich in sulfates and chlorides that aggressively attack ordinary Portland cement concrete. For any concrete in ground contact or in humid outdoor exposure — foundations, grade beams, piling caps, driveways — always specify Type V sulfate-resistant cement or a portland-pozzolan blend, a water-to-cement ratio no greater than 0.45, and a minimum cover of 3 inches over rebar. Stainless steel or epoxy-coated rebar is strongly recommended for below-grade or coastal-zone concrete in Orleans Parish. Standard Type I cement in NOLA's sulfate environment has a service life measured in decades rather than the century-plus you'd expect in drier climates.
Using the New Orleans Concrete Calculator is straightforward. Measure length and width in feet and depth in inches. Multiply length × width × (depth ÷ 12) for cubic feet, then divide by 27 for cubic yards. Always use a 10% waste factor minimum in New Orleans — the city's soft soils and irregular lot shapes frequently lead to unexpected volume needs, and calling a second partial truck adds $110–$240 in short-load fees from local suppliers. For summer pours (which is essentially April through October in NOLA), always schedule delivery before 8 AM — New Orleans' combination of 95°F+ temperatures and near-100% humidity creates an extremely aggressive hot-weather concreting environment that stiffens mixes faster than almost any other US city.
Virtually all of New Orleans lies within a FEMA Special Flood Hazard Area (SFHA). Before starting any concrete project — even a driveway or patio replacement — you must verify your property's flood zone classification and Base Flood Elevation (BFE) at FEMA's Flood Map Service Center (msc.fema.gov). Improperly placed fill, concrete slabs that reduce on-site drainage, or enclosure of below-BFE spaces can all result in violations that void your National Flood Insurance Program (NFIP) policy, trigger mandatory purchase requirements, and dramatically increase your flood insurance premiums. Orleans Parish requires a floodplain development permit from the Department of Safety and Permits for virtually all exterior concrete work — always call (504) 658-7100 before breaking ground.
New Orleans ready-mix runs $110–$126 per cubic yard — above the Deep South average due to logistics complexity, LSUCC compliance requirements, and the city's unique construction demands. Delivery fees of $110–$240 per truck apply. Installed costs below reflect current Orleans Parish market rates including labor, forming, rebar, and finishing. Piling and elevated foundation systems are priced separately and typically require a licensed structural engineer's design.
| Project Type | Typical Size | Thickness | Cu Yards | Material Cost (NOLA) | Installed Cost | PSI / Cement |
|---|---|---|---|---|---|---|
| Driveway | 20×20 ft | 5–6 in | ~6.2–7.4 yd | $682–$932 | $2,000–$4,200 | 3,500 PSI / Type V |
| Elevated Slab | 1,000 sq ft | 5–6 in | ~15.4–18.5 yd | $1,694–$2,331 | $7,500–$18,000 | 4,000 PSI / Type V |
| Piling Caps / Grade Beams | 20 LF beam | 12–18 in | ~3–5 yd | $330–$630 | $1,800–$5,500 | 4,500 PSI / Type V |
| Patio / Slab | 12×16 ft | 4–5 in | ~2.9–3.6 yd | $319–$454 | $1,100–$2,800 | 3,500 PSI |
| Sidewalk / Banquette | 4×40 ft | 4–5 in | ~2.0–2.5 yd | $220–$315 | $750–$1,800 | 3,000–3,500 PSI |
| Foundation Slab | 1,200 sq ft | 8–10 in | ~30–37 yd | $3,300–$4,662 | $9,000–$22,000 | 4,000–4,500 PSI |
| Commercial Slab | 5,000 sq ft | 6 in | ~93 yd | $10,230–$11,718 | $28,000–$62,000 | 4,000–5,000 PSI |
New Orleans sits at the premium end of the Louisiana and Gulf Coast market due to its unique construction challenges, flood zone requirements, and logistics complexity. The table below compares key Gulf Coast and Louisiana cities to help benchmark your NOLA project.
| City | Ready-Mix Range (per yd) | Labor (per sq ft) | Driveway Installed | Flood Risk | Notes |
|---|---|---|---|---|---|
| New Orleans | $110–$126 | $5.00–$9.00 | $2,000–$4,200 | Very High | Below sea level |
| Baton Rouge | $105–$118 | $4.50–$8.00 | $1,800–$3,800 | Moderate–High | LA State Capital |
| Houston TX | $108–$122 | $4.50–$8.00 | $1,850–$3,900 | High | Flood-prone city |
| Mobile AL | $102–$114 | $4.00–$7.00 | $1,600–$3,200 | Moderate | Lower cost |
| Biloxi / Gulfport MS | $103–$115 | $4.00–$7.50 | $1,600–$3,300 | High (coastal) | MS Gulf Coast |
| Lafayette LA | $104–$116 | $4.25–$7.50 | $1,700–$3,500 | Moderate–High | Acadiana market |
For small New Orleans projects under 0.5 cubic yards — post holes, small repairs, mailbox pads — bagged 80 lb concrete from local Home Depot on Tchoupitoulas Street or Lowe's on Elysian Fields runs $7–$10 per bag. For any project over 1 cubic yard, ready-mix from New Orleans-area suppliers like Vulcan Ready Mix, Louisiana Ready Mix, or Argos provides consistent LSUCC-compliant Type V sulfate-resistant mix design and saves enormous labor. For any project requiring an Orleans Parish permit — driveways, elevated slabs, foundations, commercial work — ready-mix with a certified mix design is the only acceptable choice and is required for code compliance inspections.
Official references and trusted tools for your New Orleans concrete project
Apply for building and floodplain development permits, verify flood zone elevation requirements, and schedule inspections for driveways, foundations, elevated slabs, and commercial work in Orleans Parish. Call (504) 658-7100 or visit permitsnola.com for online permit applications.
Visit NOLA PermitsVerify any Louisiana contractor's license status, classification, bond, and insurance before hiring. The Louisiana State Licensing Board for Contractors governs commercial contractors — always verify credentials at lslbc.louisiana.gov before signing any New Orleans project contract.
Check LSLBC LicenseLook up your New Orleans property's FEMA flood zone classification and Base Flood Elevation (BFE) before any concrete work. Virtually all of New Orleans is in a Special Flood Hazard Area — your BFE determines finished floor elevation requirements for elevated slabs and the permit requirements for exterior flatwork.
Check FEMA Flood Map